• Dr. Narendar Singh
• Madipeddi Shiva Shankar
• Bolli Sree Vyshnavi
• Mannepu Karthika Reddy
• Ananthagiri Srikar Prasad

A solar panel tracker is used to adjust the solar panel's direction based on the sun's direction. Here, an Arduino Uno board is used to adjust the position of the servo motor gear system by receiving inputs from an LDR sensor and a potentiometer, displaying the output on an LCD display, and making display changes. Fixing the solar panel perpendicular to the sun is the primary goal. At that moment, only the maximum number of sun rays strike the solar panel directly, increasing the quantity of power produced. To do that, we must determine if the temperature at the top and bottom of the solar panel is the same or not. Additionally, we must verify that the solar panel is fixed perpendicular to the sun beams by looking at its left and right sides. Using the numbers from the LDR sensor, I have adjusted the slope in the X direction using the Left-Right gear system and the Y direction using the Up-Down gear system

Solar panel tracking, Adaptive algorithm, Illumination-aware control, Arduino Uno, Energy harvesting efficiency, LDRs, Temperature sensors, PID control, Machine learning, Real-time data, Optimization, Renewable energy, Sustainability, Dynamic orientation, Experimental validation.

"SOLAR TRACKER", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.11, Issue 5, page no.a554-a560, May-2024, Available :http://www.jetir.org/papers/JETIR2405068.pdf

"SOLAR TRACKER", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.11, Issue 5, page no. ppa554-a560, May-2024, Available at : http://www.jetir.org/papers/JETIR2405068.pdf