• M SIVA SURYANARAYANA
• J S MANIKANTA
• K GOPI

In present days shell and tube heat exchanger is the most common type heat exchanger widely use in oil refinery and other large chemical process, because it suits high pressure application. The process in solving simulation consists of modeling and meshing the basic geometry of shell and tube heat exchanger using AUTODESK INVENTOR.. The heat exchanger contains 15 tubes, Shell length is 600 mm and shell diameter is 110 mm. Characteristics of heat exchanger design are the procedure of specifying a design, heat transfer area and pressure drops and checking whether the assumed design satisfies all requirements or not. The purpose of this thesis work is how to design the heat exchanger especially for shell-and-tube heat exchanger, which is the majority type of liquid-to-liquid heat exchanger. General design considerations and design procedure are also illustrated in this thesis. Heat transfer concepts and complex relationships involved in such exchanger are also presented.

heat exchanger, Autodesk inventor, shell and tube

"DESIGN AND STUDY OF A SHELL AND TUBE HEAT EXCHANGER USING AUTODESK INVENTOR SOFTWARE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.325-333, May-2019, Available :http://www.jetir.org/papers/JETIR1905H55.pdf

"DESIGN AND STUDY OF A SHELL AND TUBE HEAT EXCHANGER USING AUTODESK INVENTOR SOFTWARE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp325-333, May-2019, Available at : http://www.jetir.org/papers/JETIR1905H55.pdf