• Vembathurajesh A
• Mathalai Sundaram C
• Nagarajan B
• Nagaraja R
• Harikishore S

In this modern technology, the manufacturing sectors must concentrate on choosing the best machining conditions when wire electric discharge machining the toughest materials, which is extremely difficult to do using traditional machining techniques. The toughest material used in this study is machined stainless steel with dimensions of 50 x 50 x 18 mm. With distilled water acting as a dielectric fluid, 0.25 mm diameter zinc-coated brass wire is utilized as a wire tool. To optimize various input variables, a total of nine work pieces are machined with varying input parameters. With a constant wire tool feed rate, the input parameters Pulse On Time, Pulse of Time, Input Current, and Servo Voltage are changed. Following machining, Surface Roughness is measured on the machined surfaces, and the results are summarized. When compared to other pieces, the second work piece with input parameters of Pulse On Time = 115, Pulse Off Time = 55, Input Current = 230 Amps, and Servo Voltage = 10 V has a nice surface finish. Using the Taguchi Method, the input parameters for each of the nine work parts are optimized.

Optimization, Wire Cut EDM, Stainless Steel, Taguchi Method

" Optimization of Process Parameters in Wire Cut Electrical Discharge Machining of Stainless Steel by Taguchi Method", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.11, Issue 2, page no.e190-e200, February-2024, Available :http://www.jetir.org/papers/JETIR2402426.pdf

" Optimization of Process Parameters in Wire Cut Electrical Discharge Machining of Stainless Steel by Taguchi Method", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.11, Issue 2, page no. ppe190-e200, February-2024, Available at : http://www.jetir.org/papers/JETIR2402426.pdf